Hydrotherapy pools
We engineer hydrotherapy and rehabilitation pools for hospitals, aged care, physiotherapy clinics and special schools. Warm water and vulnerable users change the design brief: water treatment, heating, accessible entry and slip resistance carry as much weight as the structure.
Aquatic engineering
Typical projects
- Hospital and rehabilitation centre pools
- Aged care and retirement community pools
- Physiotherapy and allied health clinics
- Special school pools
Problems this work solves
- Warm water and water quality
- Hydrotherapy pools run around body temperature, where bacteria grow faster and disinfectant demand rises. Treatment and turnover are sized more conservatively than for a lap pool.
- Users with limited mobility
- Entry by ramp, stairs with handrails or a hoist, and floor depth changes have to be designed into the shell, not added later.
- Humidity in enclosed pools
- Indoor warm pools drive condensation and corrosion in the building around them. Ventilation and material selection have to be coordinated with the mechanical engineer.
What our engineering covers
Coreline's role is design, documentation, assessment and inspection. Construction, supply and installation sit with the builder and trades.
- Brief development with the clinical team and operator
- Shell, ramp and step design with accessible entry
- Heating, filtration and disinfection system design
- Plant room layout and hydraulic design
- Material and finish advice for slip resistance and durability
- Coordination with architect, mechanical engineer and certifier
Design considerations
- Depth zones
- Therapists usually need standing-depth zones at more than one depth. The depth profile follows the therapy program.
- Secondary disinfection
- Ultraviolet or similar secondary treatment is often considered for warm-water pools to help control chloramines and pathogens.
- Heat retention
- Covers and insulation lower heating cost, which is high for a pool held at therapy temperature year round.
What you typically receive
The exact deliverables are set in the fee proposal for each project.
- Pool structural drawings and certification
- Plant, heating and water treatment design
- Hydraulic schematics and specification
- Design basis report for the operator
What to send us
- Clinical program and expected users
- Indoor or outdoor location and building drawings
- Required water temperature and depth zones
- Access requirements, including hoists
- Operator preferences for chemicals and maintenance
Standards and regulations that usually apply
Which documents govern a design depends on the project. These are the ones most often relevant here; we confirm the applicable editions for each job.
- AS 3600
- Design and construction of reinforced and prestressed concrete structures and members.
- AS 3735
- Concrete structures that retain liquid, covering crack control, cover and watertightness.
- AS 1428.1
- Design for access and mobility, referenced by the NCC for accessible paths and entries.
- NCC (Building Code of Australia)
- Performance requirements for buildings. In Queensland NCC 2022 applies until 30 April 2027 and NCC 2025 from 1 May 2027.
Questions we are asked
How is a hydrotherapy pool different from a normal pool?
It is warmer, shallower and used by people with limited mobility, so water treatment, heating, accessible entry and slip resistance drive the design. The structure is similar; the plant and the shell geometry are not.
What temperature does a hydrotherapy pool run at?
Typically warmer than a lap pool, close to body temperature, as set by the clinical team. The chosen temperature drives heating capacity and the water treatment design.
Is a hydrotherapy pool a public swimming pool in Queensland?
Hydrotherapy pools are listed among the pools that need Queensland's public swimming pool approval. Confirm the requirements for your facility with the building certifier early in design.
Sources
Need hydrotherapy pools?
Tell us what you are building or assessing, where it is and what drawings or reports you already have. We will come back with questions, a scope and a fee.
- Phone
- 1300 924 666
- Registered engineer
- Mustafa Koc, RPEQ 35981 (Civil)
