Skip to content
Coreline Engineering

Heritage structures

We assess and design repairs and alterations for heritage-listed and older buildings, keeping as much original fabric as the structure allows. The work typically covers timber, masonry and early concrete, and is coordinated with the heritage adviser and the building certifier.

Structural engineering

Typical projects

  • Heritage-listed public and commercial buildings
  • Adaptive reuse of older buildings
  • Restumping and repairs to Queenslanders and early houses
  • Repairs to early masonry and concrete

Problems this work solves

Original fabric against current codes
Old structures rarely comply with current design standards on paper. The engineering task is to show adequate performance without replacing the fabric that gives the building its value.
Hidden deterioration
Termite damage, rot, corroded ties and decayed lintels are often concealed until opened up. Programme and budget need a contingency for what is found.
Approvals
Work on listed places needs heritage approval as well as building approval, so the repair design has to satisfy both.

What our engineering covers

Coreline's role is design, documentation, assessment and inspection. Construction, supply and installation sit with the builder and trades.

  • Condition assessment of the existing structure
  • Identification of original structural systems and materials
  • Repair and strengthening design that minimises intervention
  • Structural input to heritage impact assessments
  • Inspection during opening-up and construction

Design considerations

Repair before replace
Splicing a decayed timber member or stitching a cracked wall keeps original material and is often cheaper than replacement once access is set up.
Reversible strengthening
Where strengthening is needed, details that can be removed later without damage are preferred by heritage advisers.
Load changes from new use
A new use with higher floor loads or added plant is the most common reason heritage buildings need strengthening.

What you typically receive

The exact deliverables are set in the fee proposal for each project.

  • Structural condition report
  • Repair and strengthening drawings and specification
  • Input to heritage documentation
  • Inspection reports during works

What to send us

  • Heritage adviser's contact and any conditions already issued
  • Heritage listing details and any conservation management plan
  • Existing drawings or historical records
  • Proposed use and alterations
  • Photos and known history of repairs

Standards and regulations that usually apply

Which documents govern a design depends on the project. These are the ones most often relevant here; we confirm the applicable editions for each job.

AS 1720.1
Design of timber structures, including engineered and mass timber products.
AS 3700
Design and construction of masonry structures.
NCC (Building Code of Australia)
Performance requirements for buildings. In Queensland NCC 2022 applies until 30 April 2027 and NCC 2025 from 1 May 2027.

Questions we are asked

Does a heritage building have to be upgraded to current code?

Not in every case. The building certifier decides how far current requirements apply to the new work, and the engineer's role is to show the structure performs adequately for its use while keeping original fabric.

Can you restump a Queenslander?

We design and certify restumping, including stump sizes, footings, bracing and tie-down, and the repairs to bearers and joists that often come with it. The work itself is done by a builder.

What happens if more damage is found during repairs?

We inspect the newly exposed structure and issue revised repair details. Allowing for this in the programme and budget avoids work stopping while decisions are made.

Need heritage structures?

Tell us what you are building or assessing, where it is and what drawings or reports you already have. We will come back with questions, a scope and a fee.

Registered engineer
Mustafa Koc, RPEQ 35981 (Civil)
Add company, role and timing (optional)

We use these details only to respond to your enquiry. See our privacy policy. Please do not attach or paste plans here; we will ask for them by email once we have spoken.

Call 1300 924 666Discuss your project