Skip to content
Coreline Engineering

Pool surfaces and finishes

We advise on pool surfaces and finishes: tiles, coping and cowling details, adhesives, grouts, renders and the substrate behind them. Most finish failures start in the substrate or the movement joints, so the advice covers what sits behind the tile as well as the tile itself.

Aquatic engineering

Typical projects

  • New pools specifying tiled or rendered finishes
  • Pools with drummy or debonding tiles
  • Refurbishment and relining projects
  • Commercial concourses and wet areas

Problems this work solves

Debonding tiles
Tiles lift when adhesives do not suit the substrate, the substrate is not prepared, or movement joints are missing.
Chemical attack
Pool chemistry, especially with poorly balanced water, attacks cement-based grouts and renders over time.
Slip resistance
Concourses, steps and ramps need finishes with suitable slip resistance, particularly where users have limited mobility.

What our engineering covers

Coreline's role is design, documentation, assessment and inspection. Construction, supply and installation sit with the builder and trades.

  • Review of proposed finishes and substrates
  • Advice on adhesives, grouts and movement joints
  • Coping and cowling details
  • Investigation of finish failures
  • Specification for relining

Design considerations

Cure before tiling
Tiling too early onto new concrete risks shrinkage movement breaking the bond.
Epoxy against cement grout
Epoxy grouts resist chemicals better but cost more and are harder to install.
Movement joints
Joints in the finish should follow the structure, or tiles crack along lines of movement.

What you typically receive

The exact deliverables are set in the fee proposal for each project.

  • Finish and substrate recommendations
  • Movement joint layout
  • Investigation report for failures
  • Specification for relining or refinishing

What to send us

  • Slip resistance requirements for steps, ramps and concourses
  • Proposed or existing finish details
  • Pool construction type and age
  • Photos of any failures
  • Water chemistry records for existing pools

Standards and regulations that usually apply

Which documents govern a design depends on the project. These are the ones most often relevant here; we confirm the applicable editions for each job.

AS 1428.1
Design for access and mobility, referenced by the NCC for accessible paths and entries.
NCC (Building Code of Australia)
Performance requirements for buildings. In Queensland NCC 2022 applies until 30 April 2027 and NCC 2025 from 1 May 2027.

Questions we are asked

Why are the tiles in my pool falling off?

Common causes are adhesive unsuited to the substrate, tiling before the concrete had cured, missing movement joints and water chemistry attacking the bond. An inspection identifies which applies before retiling.

Is epoxy grout worth it in a pool?

In commercial pools and pools with aggressive water chemistry it often is, because it resists chemical attack better than cement-based grout. It costs more and needs experienced installers.

Do pool steps and concourses need slip-resistant finishes?

Yes. Wet areas around pools are high slip risk, and access paths, ramps and stairs should use finishes with suitable slip resistance.

Need pool surfaces and finishes?

Tell us what you are building or assessing, where it is and what drawings or reports you already have. We will come back with questions, a scope and a fee.

Registered engineer
Mustafa Koc, RPEQ 35981 (Civil)
Add company, role and timing (optional)

We use these details only to respond to your enquiry. See our privacy policy. Please do not attach or paste plans here; we will ask for them by email once we have spoken.

Call 1300 924 666Discuss your project